Pipe cutting power unit

MAIN FEATURES INCLUDE:
- Throttle valve: The high-quality throttle valve imported from Italy can accurately control the oil flow, ensuring the smooth, stable and accurate feed of the tool during the cutting process under the condition of high-temperature hot-pressed oil. The characteristics of slow feed and fast retract enable higher processing accuracy and efficiency in the pipe cutting process.
- 360° rotation design: Considering that the cutting machine needs to rotate in all directions, the hydraulic unit is specially designed with a thickened flange oil tank to increase the stability and pressure resistance of the structure, ensuring the balance during the rotation process and the stable supply of fluid.
- Motor power and voltage selection: The motor power is 0.55kW, which can provide sufficient power. At the same time, due to its low power and strong stability, it also helps to reduce energy consumption. The voltage range supports 220V to 380V selection to adapt to different power configurations.
- High temperature adaptability: The design of the pipe cutting power unit takes into account the working environment of high temperature hot oil, ensuring that the system can operate for a long time under such conditions, avoiding overheating and pressure fluctuations, and ensuring a smooth cutting process.

This pipe cutting power unit is very suitable for pipe cutting machines, especially in scenarios where precise feed and fast retraction are required. Through high-quality imported components and optimized design, it ensures a stable and efficient cutting process and can cope with the challenges of high temperature working environments. The system design not only focuses on operating accuracy, but also enhances durability and energy efficiency to adapt to different working conditions.

SPECIAL NOTES

The power unit is an S3 working system and can not operate continuously. It starts in 10 seconds and stops in 90 seconds.

Before installation, ensure that hydraulic components such as the oil cylinder, oil pipe, and joint are free of impurities.

The viscosity of hydraulic oil shall be 15 - 68st. No. 46 anti-wear hydraulic oil is recommended in summer, and No. 32 low-temperature hydraulic oil is recommended in winter.

After starting the operating system for the first time, check whether the oil in the oil tank is sufficient, generally 2 / 3 of the oil tank.

After the system is used for the first 100 hours, the hydraulic oil shall be replaced, and then the hydraulic oil shall be replaced every 3000 hours.

SCHEMATIC DIAGRAM

SPECIFICATIONS

Note: if you need system parameters such as pump, pressure, and motor power with different flow, please contact our salesman.